Privacy Collection Statement-The Firepower 2100 does not require or activelyĬollect personally-identifiable information. See Reimage the Cisco ASA or Firepower Threat Defense Device. Switching between ASA and threatĭefense requires you to reimage the device. The Firepower 2100 hardware can run either ASA software or threatĭefense software. This chapter also walks you through configuring a basic security policy if you have more advanced requirements, refer to This chapter does not cover the followingĭeployments, for which you should refer to the ASA configuration guide: Runs in Appliance mode, so this chapter tells you how to set the mode to Platform mode.
This chapter describes how to deploy the Firepower 2100 in your network in ASA Platform mode. Only advanced troubleshooting commands are available from the FXOS See the FXOS troubleshooting guide forĪppliance mode (the default)-Appliance mode lets you configure all settings in You must view moreĭetailed interface information using FXOS commands. For FXOS troubleshooting commands, see the FXOS troubleshooting guide.įor many interface show commands, you either cannot use the ASAĬommands or the commands lack the full statistics. For the full FXOS configuration guide, see the FXOS ASA configuration guide. You can then configure your security policy in the ASA operating system using ASDM or the ASAĬLI. You can use the chassis manager web interface or FXOS CLI. These settings include enabling interfaces, establishing EtherChannels, NTP, image management, and more. Platform mode-When in Platform mode, you must configure basic operating parameters and hardware interface settings in FXOS.
You can run the Firepower 2100 for ASA in the following modes: The Firepower 2100 runs an underlying operating system called the FXOS. ASA Platform Mode Deployment with ASDM and Chassis Manager
0 kommentar(er)
